3.10 E-Mail
Using E-Mail function, user can send an e-mail with attached image file that has been shot
triggered with an external sensor or the built-in object detection function. The image file also
can be sent periodically.
Common
You may setup SMTP mail parameters for future event-message receiving such as object
detected or sensor activated.
E-Mail Enable:
To enable or disable E-Mail function.
E-mail to:
Type the receiver’s e-mail address.
Note
: you can specify multiple recipient email
addresses at the time.
From:
Type the sender’s E-mail address. This address is used for reply e-mails.
Subject:
Type the subject/title of the e-mail.
SMTP Server:
Type the SMTP server name or the IP address of the SMTP server.
Port:
Set port number of SMTP service.
Need Authentication:
Select the authentication required when you send an e-mail.
On
: if authentication is required when an e-mail is sent.
Off
: if no authentication is required when an e-mail is sent.
User name:
Type the user name for the SMTP server if
Authentication
is
On
.
Password:
Type the password for the SMTP server if
Authentication
is
On
.
SMTP Test:
Send a test mail to mail server to check this account is available or not.
3.11 FTP
Use this menu to set up for capturing and sending still images to an FTP server. Using FTP
42/57
