CLIP-ON FENDERS
MOUNTING INSTRUCTIONS
FOR MODELS: 7001 & 7002
STEP 1:
Consult the below Tire Reference
Guide to confirm you have the correct size
fenders for your bike. If your tires are
larger than our recommended maximum
tire width, do not install fenders.
Mounting Front Fender:
Place steel
hanger (B) on front fender and press
forward to secure it to the plastic tab.
Pass the 15mm hex-head bolt (E) through
from underside of front fender. Thread
the quick release nut (C) on the bolt to
secure the steel hanger to the fender.
STEP 2:
On the back side of the fork
crown, thread the 43mm bolt (H)
through the steel hanger and concave
washer (D). Secure with lock nut (I) and
washer (G).
C
B
I.
J.
K.
I.
G.
G.
D.
D.
F.
H.
H.
E.
C.
A.
B.
E
STEP 3: Mounting Rear Fender:
OPTION A:
If hole is present on the seat
stay bridge, snap plastic clip onto fender
as shown above. Attach front of rear
fender to seat tube and adjust plastic
clip to line up with bridge hole. Secure
clip to bridge using 30mm bolt
(F)
, add
plastic concave washer
(D)
, flat
washer
(G)
and lock nut
(I)
. You will need
to use both a 10mm wrench and
screwdriver to tighten bolt.
OPTION B:
If no hole is present on the
seat stay bridge, snap plastic clip
(A)
onto fender as shown above. Attach
front of rear fender to seat tube and
adjust plastic clip to line up with seat
stay bridge. Secure clamps around
bridge. If clamps don’t fit snugly, we
don’t recommend using this fender.
A)
Plastic clip
B)
Steel hanger
C)
Quick release nut
D)
Plastic concave washers(x2)
E)
15mm bolt
F)
30mm bolt
G)
Washers (x2)
H)
43mm bolt
I) Lock nut (x2)
Not Included:
Tools You’ll Need for installation
J)
Phillips screw driver
K)
10mm box wrench
STEP 1
STEP 2
OPTION A
OPTION B
