Planar Wallnet, Настройка и эксплуатация

Страница: 31 / 88

25
Save WallNet Config
Save WallNet Config
All the configurations you previously set are now
in RAM in the WallNet device server, but they will
disappear if the box loses power or is rebooted.
1 In the menu area, select Save WallNet
Config.
2 Click Save configuration settings now . It
takes about 30 seconds to save settings.
Once this is complete, you will see the
following message:
Compressing configuration
files...done.
Saving configuration files to
flash...done.
Select Display Product
WallNet has several versions of software, each of
which supports a set of displays. For example,
LED Series,
cXXRP/RX/SP and Margay II are combined
into one
WallNet software version, while support
for mXXL and Clarity Matrix is provided in a
separate WallNet software version. These
independent WallNet software versions are
distributed as binary files with the extension
.wn .
To switch between them, you must load the
appropriate software file into WallNet. (See
"Finding WallNet’s Address" on page 75.) WallNet
only has enough memory for one of these
software “images.” Depending on which version
has been loaded, you may see different options in
the Select Display Product Type section.
If the WallNet software requires that you select a
specific display product, use the following
instructions.
1 In the menu area, select WallNet Software.