26
Ventilation
3
1.
Ensure that the air can circulate freely around the back of the appliance.
2.
A ground clearance of 15 mm is required.
3.
If the appliance is installed below an overhanging wall unit, a minimum distance
of 100 mm between the overhanging wall unit and the top of the appliance is
required. Ideally, however, the appliance should not be installed below
overhanging wall units.
4.
If the appliance is installed in a corner with the hinges facing the wall, a
minimum distance of 10 mm between the appliance and the wall is required; so
you can open the door enough to e.g. remove the shelves.
3.2 Changing of the hinge position
WARNING!
Switch off and unplug the appliance before changing the
hinge position. RISK OF ELECTRIC SHOCK!
CAUTION!
The change of the hinge position must be carried out by
at least two persons; otherwise you may hurt yourself or damage the
appliance. Do not tilt the appliance more than 45
0
.
NOTICE!
Adjust the door properly. The seal must close properly.
1.
Tilt the appliance carefully backwards so that the compressor will not touch the
floor.
2.
Unscrew the left feet.
3.
Unscrew the screws of the bottom hinge.
4.
Remove the door by pulling it slightly downwards.
5.
Unscrew the top hinge pin and install it on the opposite side.
3
Schematic drawing is valid for all models.
