23
Carbon filter
Unplug the appliance before installing
the carbon filter.
For recirculating mode only.
Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed at three or six months according to your cooking habit. Activated
carbon filter cannot be washed or recycled. The installation procedure of activated
carbon filter is as below.
1. Slide the front part of the cooker hood.
2. In order to install the activated carbon filter, the Al anti-grease filter should be
detached first. Press the lock and pull it downward.
3. Put the activated carbon filter into the unit on the side of motor and turn it in clockwise
direction. Repeat the same on the other side. Put back to the grease filter in position.
Note: When the activated carbon filter attached, the suction power will be lowered.
3. Control panel
CAUTION!
The lamp must not be covered by thermal insulation or
other materials. Do not touch the illuminant within 30 minutes after
operation.
NOTICE!
Only switch on the lights while the appliance is operating. Do not
switch on the lights to lighten the room.
NOTICE!
Never press two buttons simultaneously.
Digital display key
➢
Turn the Hood ON and OFF
➢
The Display will show you the current power level
Power down key
➢
With this key the power level could be reduced.
