Pixsys PLE500-6AD, Руководство пользователя, Страница: 7 / 32

User manual - PLE500 - 7
4 Dimension and installation
64 mm
Attacco a guida DIN EN50022
Din rail mounting guide EN50022
PLE500-6AD
54 mm
90 mm
.4 .5 .6 .7 .3 .2 .1 .0
.4 .5 .6 .7 .3 .2 .1 .0
+0
+1
1 2 3 4 5 6 7 8 9 10 12
QI.0 QI.1 QI.2 QI.3 QI.4 QI.5 QI.6 QI.7
13 14 15 16 17 18 19 20 21 22 23 24
A
GN
D
(0
V)
A
I0
L+0 A
I1
QI.0 QI.1 QI.2 QI.3
QI.4 QI.5
QI.6 QI.7
L+1 A
Q.0
A
Q.1
A
GN
D
(0
V)
4.1 Mounting sequence of the PL500 and of the PLE500
expansion modules
The PL500 with the relevant I/O modules requires mounting and connection via the specific bus
lodged in the hollow of the DIN rail. The I/O modules (series PLE500-xAD) will be automatically
numbered at each power-on, assigning the number 1 to the first I/O module connected to the right
of the PL500, the number 2 to the following one and so on, always moving towards the right side.
The position of the various modules shall thus reflect the sequence set in the LogicLab project in the
definition of the PLCEXP network. For the numbering procedure to work correctly, removing devices
from the network is not allowed by releasing them from their own bus and leaving some empty
modules (slot bus) between one module and the other. All the connection/disconnection operations
must be carried out with power off.
Clik!
Couple all the buses by pushing them towards the DIN
rail, making sure that the male connection faces left
and the female one faces right.
Couple the buses together by sliding them along the
DIN rail.
Insert the various modules in the slots of the buses
starting from the PL500 and continuing to the right
with the I/O modules.