Piusi PW Mobile, Инструкция по установке и эксплуатации

Страница: 43 / 64

43
/124 43
/64
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
translated from italian
PW Mobile
11.2 PW MOBILE INSTALLATION ON CUBE MC 2.0
11.2.1 INSTALLATION ON THE BACK
1 Use the measurements described in the image to place the “CUBE DRIL-
LING GUIDE” on the back of the Cube
2 Make 3 holes on the sheet in the positions indicated on the guide, with a ø 5
tip: be very careful not to damage cables and internal components
3 Assemble the PW Mobile case on the Cube, through the case holes, using
supplied screws and nuts
4 Insert the power and RS485 DB9 cables from an opening in the Cube base
5 Proceed with wiring as described in chapter 11.4
68
CUBE