19
/124
19
/48
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
translated from Italian
FULL PACK MC BOX etl
MOUNTING ON A
PEDESTAL
75
22.8
236
286
Ø
9
4x
optional
WARNING
PROVIDE FOR THE INSTALLATION OF MCBOX B-SMART IN AREAS
WHERE THERE IS NO RISK OF EXPLOSION
12.2 HAZARDOUS AREA
Any fuel dispenser is a hazardous area as defined in the National Electrical Code. Installation must be
in accordance with the following:
¦ National Electrical Code (NFPA No. 70);
¦ Automotive and Marine Service Station Code (NFPA No. 30A).
WARNING
The installer is responsible to investigate and follow any local codes.
MC BOX Bsmart ETL is listed for use in a non-classified area. All of the
equipment must be installed outside of the hazardous areas.
NOTE
Local codes may dictate specific installation requirements. Installation is
subject to approval by the local authority having jurisdiction at the site.
12.3 ELECTRICAL CONNECTIONS
ELECTRICAL
CONNECTIONS
The electrical connections must be carried out in a workmanlike manner by
specialised personnel, in full compliance with the regulations in force in the
country of installation and with the instructions in the electrical diagrams in
this manual.
WARNING
The MC BOX B.SMART Electronic Panel is NOT equipped with circuit
breakers; it is therefore essential to install upstream MC BOX B.SMART
an electrical power supply panel equipped with a circuit breaker /
disconnector with a current rating suitable for the electrical line and a
differential switch suitable for the type of electrical load.
Otherwise, provide for a quick disconnection system such as a socket/plug
connection to be used in the event of faults.
WARNING
Before accessing the electrical parts, make sure that you have
disconnected all the main switches that energize the unit.
