M0502
16
/28
Installaltion, use and maintenance
13.3 DAILY USE
FOREWORD
The only operations that need to be done for daily use are partial and/or reset-
table total register resetting. The user should use only the dispensing system
of measurement device. Occasionally the meter may need to be configured or
calibrated. To do so, please refer to the relevant chapters.
Below are the two typical normal operation displays. One display page shows the partial and reset
total registers. The other shows the partial and general total. Switchover from resettable total to
general total display is automatic and tied to phases and times that are in factory set and cannot be
changed.
NOTE
6 digits are available for Totals, plus two icons x 10 / x100. The incre-
ment sequence is the following:
0.0 -> 99999.9 -> 999999 -> 100000 x 10 -> 999999 x 10 ->100000 x
100 -> 999999 x 100
13.4 DISPENSING IN NORMAL MODE
FOREWORD
Normal mode is the standard dispensing. While the count is made, the partial
and resettable total are displayed at the same time (reset total).
WARNING
Should one of the keys be accidentally pressed during dispensing, this
will have no effect.
STAND BY
A few seconds after dispensing has ended, on the lower register, the display
switches from resettable total to general total: the word reset above the word
total disappears, and the reset total is replaced by the general total.
This situation is called standby and remains stable until the user operates the
measurement device again.
