M0502
14
/28
Installaltion, use and maintenance
12.2 FLOW RATE ADJUSMENT LEVER
NOTE
The adjustment lever is located on the side of the trolley.
ATTENTION
This function is only valid for the DELPHIN PRO and DELPHIN IBC models.
In the DELPHIN PRO-X model the flow rate is regulated by the management sys-
tem.
Lever in the
LOW FLOW RATE
position
Lever in the
STOP
POSITION
(present only in
Delphin PRO model)
Lever in the
HIGH FLOW RATE
position
ATTENTION
Use the flow rate adjustment lever as indicated.
Use in “Van” mode when filling a car could result in damage to the vehicle.
12.3 PHASES OF DELIVERY
1
Connect the connector to the tank by screwing it clockwise
2
Press POWER button A.
3
Press the REFILL button B for 3 seconds.
4
Wait for the filling end.
5
Disconnect the connector from the tank by unscrewing it counter-clockwise.
6
Place the connector in the appropriate housing by screwing it clockwise.
ATTENTION
DO NOT USE IF:
- THE CONNECTOR IS NOT COMPLETELY CONNECTED TO THE CAR TANK
- THE CONNECTOR IS NOT CONNECTED TO THE SAFETY HOOK.
