SKU
68783
For technical questions, please call
1-800-444-3353
Page:
3
7. Center the vehicle’s lifting point(s) on the saddle of
the jack stand(s). Set the jack stand(s) according
to the manufacturer’s instructions, making
sure that they lock securely into position.
Note:
Always set both Jack Stands at the same height.
8. Slowly turn the Handle counterclockwise to lower
the vehicle onto the saddle(s) of the jack stand(s).
Then, turn the Handle firmly clockwise to close it.
Lowering
1. Carefully remove all tools, parts, etc.
from under the vehicle.
2. Position the Saddle under the lifting point. Turn the
Release Screw firmly clockwise and pump the Handle
to raise the vehicle slightly above the saddles of the
jack stands. Then lower the Jack Stand Saddles to
their lowest position and carefully remove jack stands.
3. Slowly turn the Handle counterclockwise (never more
than two full turns) to lower the vehicle onto the ground.
4. Lower the Jack completely. Then, store in a
safe, dry location out of reach of children.
Inspection, Maintenance, & Cleaning
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal
noise or vibration occurs, have the problem
corrected before further use.
1. Before each use, inspect the general condition of the
Jack. Check for broken, cracked, or bent parts, loose
or missing parts, and any condition that may affect the
proper operation of the product. If a problem occurs,
have the problem corrected before further use.
Do not use damaged equipment.
2. Before each use, thoroughly test the Jack
for proper operation prior to its actual use.
If the Jack appears not to be working properly,
follow Bleeding instructions on page 2.
3. Change hydraulic oil at least once every three years:
a. With the Jack fully lowered, remove the Oil
Fill Screw on the side of the Hydraulic Unit.
b. Tip the Jack to allow the old hydraulic oil to drain out
of the Housing completely, and dispose of the old
hydraulic oil in accordance with local regulations.
c. With the Jack upright, completely fill the Housing
with a high quality hydraulic oil (not included) until
the oil just begins to run out of the oil fill hole.
d. Open the Release Screw and pump the
Handle to bleed air from the system.
e. Recheck oil level and re-fill as needed.
f. Reinstall the Oil Filler Plug.
4. Wipe dry with a clean cloth. Then, store the
Jack in a safe, dry location out of reach of
children and other non-authorized people.