Safety Information
This document contains safety information related to the AddressRight™ 100, 200, and 300 printers and
AddressRight™ 300 Feeder.
To avoid personal injury or damage to the equipment, familiarize yourself with proper procedures and
methods before you install, operate or repair the system.
Follow these safety precautions whenever you use your address printer:
l
Use this equipment for its intended purpose.
l
Place the system close to an easily accessible wall outlet.
l
Be certain the area in front of the wall receptacle into which the machine is plugged is free from
obstruction.
l
Place the system in an accessible location to allow for proper venting of the equipment and to
facilitate servicing.
l
Use AC power cord included with device.
l
Plug the AC power cord directly into a properly grounded wall outlet located near the equipment
and easily accessible. Failure to properly ground the machine can result in severe personal injury
and/or fire.
l
The AC power cord is the primary means to disconnect this device from the AC power supply.
l
DO NOT use an adapter plug on the line cord or wall outlet.
l
DO NOT use a wall outlet controlled by a wall switch or one that is shared with other equipment.
l
DO NOT remove the ground pin from the line cord.
l
Always unplug the printer and discharge static electricity before using aerosol dusters.
l
Improper storage and use of aerosol dusters or flammable aerosol dusters can cause an
explosive-like condition that could result in personal injury and/or property damage.
l
Never use aerosol dusters labeled flammable and always read instructions and safety precautions
on the duster container label.
l
DO NOT route the power cord over sharp edges or trap it between pieces of furniture. Make sure
there is no strain on the cord.
l
Use only approved supplies.
l
Operation of this equipment without periodic maintenance will inhibit optimum operating
performance and could cause the equipment to malfunction.
l
If the unit becomes damaged, unplug it from the wall.
l
Keep fingers, long hair, jewelry and loose clothing away from moving parts at all times.
l
Always follow specific occupational safety and health standards for your workplace.
l
Remove jammed material gently and carefully.
l
To reduce the risk of fire or electrical shock, DO NOT attempt to remove covers or disassemble the
control panel or its base. The cabinet encloses hazardous parts.
l
Avoid touching moving parts or materials while the machine is in use. Before clearing a jam, be
sure machine mechanisms come to a complete stop.
l
Before operating the AddressRight™ Printer/Feeder, make sure that it has been properly
prepared and that any other personnel in the area are standing clear of the machine.
Pitney Bowes
User Guide October 2019
9