Safety
General Safety
Follow normal safety precautions for all office equipment:
l
Use only Pitney Bowes approved supplies, in particular aerosol dusters. Improper storage and use of aerosol dusters or flammable aerosol dusters
can cause an explosive-like condition that could result in personal injury and/or property damage. Never use aerosol dusters labelled flammable and
always read instructions and safety precautions on the duster label.
l
This printer is powered by an external AC power adapter. Use only the AC power adapter and AC power cord supplied with the printer and plug it
into a properly grounded wall outlet that’s located near the printer and easily accessible. Failure to properly ground the power adapter can result in
severe personal injury and/or fire.
l
The power cord wall plug is the primary means of disconnecting the power adapter from the AC supply. The power adapter is on whenever it is
plugged into a live receptacle.
l
To obtain supplies, please contact our Supply Line™ to place orders
l
Material Safety Data Sheets can be obtained through the web or from our Supply Line™. Refer to the Contact Information List for more information.
l
Avoid touching moving parts or materials while the machine is in use. Keep hands, loose clothing, jewellery and long hair away from all moving parts.
l
Do not remove covers or defeat safety interlock switches. Covers enclose hazardous parts that should only be accessed by properly trained service
personnel. Immediately report to service any damaged or non-functioning components that renders the unit unsafe.
l
Place the unit in an accessible location to allow for proper venting of the equipment and to facilitate servicing.
l
The power cord wall plug is the primary means of disconnecting the machine from the AC supply.
l
Do not use an adapter plug on the line cord or wall outlet.
l
Do not remove the ground pin from the line cord.
l
Place the printer so the AC power adapter is close to an easily accessible wall out let. DO NOT use a wall outlet controlled by a wall switch or one
that is shared with other equipment.
l
DO NOT route the power cord over sharp edges or trap it between pieces of furniture. Make sure there is no strain on the power cord.
l
DO NOT route the DC power cable that plugs into the printer over sharp edges or trap it between pieces of furniture. Make sure there is no strain on
the DC power cable.
l
Make sure the area in front of the wall outlet into which the AC adapter is plugged is free from obstruction.
Pitney Bowes
Installation Instruction June, 2020
Page 13 of 15