INSTALLATION & OPERATIONAL SSHLV MANUAL
12
L20-407 rev.5 (06/19)
2.11.
INITIAL ADJUSTMENTS
After your appliance has been properly installed as described in the installation section of this manual,
it will need to be adjusted to ensure that it will perform as designed. A qualified person must perform
these adjustments.
To perform these adjustments the following tools will be needed:
Manometer
Digital Thermometer (Temperature Probe)
DC Microammeter
DC Voltmeter
2.11.1. FILLING THE APPLIANCE
Refer to the following procedure to fill the cook tank prior to operation.
1. Ensure that the drain valve is closed.
2. Fill the tank to about ½” (1.25 cm) below the oil level line with oil/shortening. The oil/shortening
level will rise slightly as it heats up. Never let the oil/shortening level go below the MIN LEVEL
mark stamped on the tank.
2.11.2. LIGHTING INSTRUCTIONS
There is nothing to manually light on the SSHLV system. Pilot ignition is performed and controlled
by the electronic ignition system. Refer to the following instructions to light the appliance.
1. Verify that all electrical connections, clearances, gas connections, ventilation requirements and
gas pressures have been properly implemented, tested, adjusted and checked for compliance in
accordance with the instructions and requirements in Section 2 of this document prior to
proceeding.
2. Open the gas supply valves to the appliance.
3. Turn the gas valve knob to the ON position.
4. Turn the controller on. Press the
button to turn the COMPUTER on.
5. The main burners will light and be controlled by the computer.
Note: If your appliance has a self cleaning burner system, the burners may make a popping
sound immediately after the main burners light during startup. This noise during startup is
part of the normal operation of the self cleaning burner system and should NOT continue
during normal cooking & idle periods. (SCB Only)
WARNING
Oil/shortening must completely cover the heat tubes at all times while appliance is on.
CAUTION
This appliance is not designed for cooking with water. Fill with oil/shortening only.
WARNING
During operation there is an open flame inside this appliance. The unit may get hot enough to
set nearby materials on fire. Keep the area around the appliance free from combustibles.
