Piscine Solide V35048, Руководство по установке

Страница: 33 / 49

No Diving or Jumping. Observe all Safety Rules
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
Section
3
2-2. For STANDARD/BEADLOCK/SNAPBEAD
LINER ONLY
(Please see step 2-1. or 2-3. for other liner)
a. With a snap bead liner you will not use the plastic coping
strips that are packed in the parts carton of many pools.
You can discard those pieces (if they are included).
Instead, you should have received a beaded liner track
(referred to as a “coping bead receiver” in
Image 24
).
b. The beaded liner track should be installed onto the
pool wall all of the way around the pool. These pieces
should be as close together as possible. Leaving spaces
between bead tracks can cause liner problems later on.
c. Once all of the beaded liner track is on the wall, you can
snap the liner bead into the beaded liner track at four
random points around the pool. After that is done, and
you are satisfied with how the liner is situated within the
pool, you can continue snapping the remainder of the
liner into place around the pool.
d. Go around the entire pool again making certain that the
liner is securely snapped into the track. This is important
to confirm so that the liner does not pull out while under
the pressure of being filled with water.
NOTE: Some liners may fit very tightly, it is better to install
uprights, top plate and rail before going onto next step.
See Section 4.
3. Proceed to Section 4 -
Installing the Pool Frame
C. CONT. INSTALL THE POOL LINER
21
3-9
SLOTTED TUBE