Page
13
of
15
2. Place the Mop Head on top of the Resting pad, and allow the unit to
cool for at least 30 minutes for complete cooling.
3. For convenience it is recommended to disconnect the Telescopic Tube,
and if attached, remove the Microfibre Pad from the Mop Head.
Removing these during the cleaning process will make cleaning easier.
4. Remove the Water Tank / Boiler Cap and drain any water remaining in
Water Tank / Boiler into a sink or tub as described previously.
5. Fill the Measuring Cup with white vinegar. (250ml)
6. Pour the vinegar into the Water Tank / Boiler through the Water tank /
Boiler Fill Hole.
7. Allow the vinegar to soak in the Water Tank / Boiler for 30 - 40 minutes.
8. Drain the vinegar from the Water Tank / Boiler into a sink or tub.
9. Refill the Water Tank / Boiler with fresh clean water, swill around, drain
and repeat until the vinegar odour dissipates.
10. Replace the Water Tank / Boiler Cap (do not fully tighten), reconnect the
Telescopic Tube and store your Steam Mop as mentioned in the
“Storage” section.
Note
: Never fill the Water Tank / Boiler with any chemicals, cleaners,
solvents or the like.
11.2 Cleaning the Microfibre Pads
The Microfibre Pads must be cleaned regularly for best cleaning
performance.
Simply wash the Microfibre Pads in warm mild soapy water, rinse in clean
fresh cold water and let air dry.
The Microfibre Pads may be washed in a washing machine on a Normal
Wash. Wash separately to other items.
To avoid picking up lint, wash separately from other fabric is recommended.
Only use liquid detergent. Avoid using any fabric softeners or bleach.
DO NOT
Scrub, Tumble Dry or Iron the Microfibre Pads
