Piper PA-24 Comanche, Руководство по обслуживанию

Страница: 154 / 846

PIPER COMANCHE SERVICE MANUAL
III - INSPECTION 04/01/09
1D16
TABLE III-I. INSPECTION REPORT - PA-24 / PA-24-250/260/400
(cont.)
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
B. ENGINE GROUP (CONT.)
13. Inspect cylinders for cracked or broken fins .......................................................... O
14. Fill engine with oil per lubrication chart and Table II-VI ...................................... O O
CAUTION: DO NOT CONTAMINATE VACUUM PUMP WITH CLEANING
FLUID.
15. Clean engine........................................................................................................... O
16. Inspect condition of spark plugs. (Clean and adjust gap as required,
0.015 to 0.018 or 0.018 to 0.022 per latest revision of
Lycoming Service Instruction No. 1042.)..............................................................
O
NOTE: If fouling of spark plugs has been apparent, rotate bottom plugs to upper plugs.
17. Inspect ignition harnesses and insulators for high tension leakage
and continuity......................................................................................................... O
18. Inspect magnetos. (See Notes 6 and 9.) ................................................................. O
19. Remove air cleaner screen and clean. (Refer to Section II.).................................. O O
20. Drain carburetor and remove and clean carburetor inlet screen or
remove and clean fuel injector inlet screen.
(Clean injector nozzles as required.) (Clean with acetone only.)...........................
O O
21. Inspect condition of carburetor heat or alternate air door and box ........................ O O
22. Inspect intake seals for leaks and clamps for tightness.......................................... O
23. Inspect condition of flexible fuel lines................................................................... O
24. Inspect fuel system for leaks. (See Note 19.)......................................................... O O
25. Clean screens in plunger type electric fuel pump(s) per paragraph 8-23............... O O
26. Inspect engine-driven and electric fuel pumps for condition and operation.
(See Note 6.) .......................................................................................................... O
27. Inspect vacuum pumps and lines. (See Notes 15 and 25.) ..................................... O
28. Inspect throttle, carburetor heat or alternate air, mixture
and propeller governor controls for travel and operating condition....................... O
29. Inspect exhaust stacks, connections and gaskets per
Exhaust System Inspection under Special Inspections, Procedures.
Replace gaskets as required. (See Note 26.) ..........................................................
O O
30. Inspect muffler, heat exchanger and baffles per
Exhaust System Inspection under Special Inspections, Procedures. .................... O
31. Inspect breather tube for obstructions and security ............................................... O
32. Inspect crankcase for cracks, leaks and security of seam bolts ............................. O
33. Inspect engine mounts for cracks and loose mounting .......................................... O
34. Inspect rubber engine mount bushings for deterioration ...................................... O
35. Inspect all engine baffles for cracks....................................................................... O
36. Inspect firewall for cracks ...................................................................................... O
37. Inspect condition of firewall seals.......................................................................... O
38. Inspect condition and tension of generator or alternator drive belt ....................... O
39. Inspect condition of generator or alternator and starter ......................................... O