Piper ARROW III, Руководство по обслуживанию

Страница: 88 / 594

TABLE III-I. INSPECTION REPORT (cont)
18. Refer to latest revision of Piper Service Bulletin 578.
19. Inspect brushes every 100 hours if used for training or every 500 hours if used for normal service. (Refer
to latest vendor service publications.)
20. Refer to flight manual supplement for preflight and flight check, for intended function in all modes.
21. Refer to latest revision of Bendix Service Bulletin 612 for inspection of magneto and ignition
harnesses.
22. Refer to latest revision Teledyne Continental Service Bulletin M86-11.
23. Examine cables for broken strands by wiping the cable along the length of the cable. Visually check for
damage. Replace all damaged cables. Refer to latest revision of Advisory Circular 43.13.
24. Piper Service Bulletin 884 compliance requires lock wiring of V-band couplings.
25. Latest models, S/N’s 2837001 (PA-28R-201) and S/N’s 2803001 (PA-28R-201T) are equipped with
auxiliary electric backup vacuum systems that require replacement after 500 hours of operation time.
26. Piper Service Bulletin 896 compliance requires installation and usage of shoulder harnesses.
27. Refer to latest revision of Piper Service Bulletin 866a. Aircraft S/N’s 2837001 (PA-28R-201) and up,
and S/N’s 2803001 (PA-28R-201T) and up, have no backup extender system in the landing gear system
installed as standard equipment.
28. When servicing or inspecting vendor equipment installed in Piper aircraft, it is the user’s responsibility to
refer to the applicable vendor service publications.
29. Ensure after cleaning engine that all rod end bearings are lubricated with at least 3 drops of 100W motor
oil.
30. All inspections or operations are required at each of the inspection intervals as indicated by an (O). Both
the annual and 100 hour inspection are complete inspections of the airplane, identical in scope, while
both 500 and 1000 hour inspections are extensions of the annual or 100 hour inspections, which require a
more detailed examination of the airplane and overhaul or replacement of some major components.
Inspections must be accomplished by persons authorized by the FAA.
31. Refer to latest revision of Service Bulletin 856.
32. Inspect Teflon bushing (lower to upper cowling attachment) for condition at each 100 hours. Replace
bushing on condition, but no later than 500 hours time in service. Inspect pin for condition and replace as
necessary.
33. If not already installed, add access panels per instructions in Section IV, Paragraph 4-55a. See latest
revision of Piper Service Bulletin 977.
34. Special care should be taken to inspect stabilator control cables beneath aft baggage compartment floor.
Add access panels per instructions in Section IV, Paragraph 4-55a, to ease this inspection.
Interim Revision: 2/21/95
1D16
CHEROKEE ARROW III SERVICE MANUAL
INSPECTION