iPod/iPhone playback
03
15
En
English
Français
Español
SHUFFLE
2
Two iPod/iPhone units can be played
alternately with no break in sound (
SHUFFLE
2
).
A bit before the currently playing iPod/iPhone
track ends, playback begins on the other iPod/
iPhone track and the volume is gradually
raised to fade in seamlessly (Cross fade).
During the
SHUFFLE
2
operation, the order of
track playback is set by the shuffle function.
1
Connect two iPod/iPhone units to the
iPod/iPhone connector ports (iPod a, iPod b),
then press iPod a or iPod b.
2
Press MENU to access the iPod/iPhone
menu.
3
Select the track area that you want to
play back, then press ENTER.
4
Press .
The
SHUFFLE
2
mode is set, and the
SHUFFLE
2
indicator lights; the unit connected to the iPod
a
connector port will playback.
A bit before the currently playing iPod/iPhone
track ends, the other iPod/iPhone unit begins
cross fade playback. The same operation is
repeated thereafter until all tracks on both
units have been played.
1
• To cancel the
SHUFFLE
2
mode, press either
once again, or
.
• The
SHUFFLE
2
mode will also be canceled
if the function is switched to any another
input (including iPod
a
or iPod
b
).
HI-LITE Scan
Each track is played back for a few seconds at
a certain time from the track beginning, thus
allowing desired tracks to be found quickly.
1
Connect an iPod/iPhone to the iPod/
iPhone connector ports, then press iPod a or
iPod b.
2
Press MENU to access the iPod/iPhone
menu.
3
Select the track area that you want to
play back, then press ENTER.
4
Press HI-LITE.
HI-LITE scan function will begin from the first
track on the selected iPod/iPhone.
If playback was already underway, the HI-LITE
scan will begin from the currently playing
track.
After a track is played for a few seconds, the
next track will be found and a certain time
2
from the track beginning will be played for a
few seconds.
When two iPod/iPhone units are connected
simultaneously, the first track on the alternate
iPod/iPhone will be found and a certain time
from the track beginning will be played for a
few seconds.
Thereafter, the same process will be repeated
until all tracks have been found and played for
a few seconds each.
• To cancel the HI-LITE Scan operation,
press
HI-LITE
once more.
• The HI-LITE Scan mode will also be
canceled if the function is switched to any
another input (including
iPod a
or
iPod b
).
Note
1 During Cross Fade operation,
/
, and
/
are deactivated.
2 If a track
’
s total length is too short, the track will be played back from the track beginning for a few seconds.
XW-NAC3_CUZXTSM.book 15 ページ ２０１０年４月６日 火曜日 午後１時１８分
