65
≫
≫
≫
≫
≫
≫
Playing Back
Set the remote controller to the ZONE control mode(
p64
the following operations.
1.
Point the remote controller at the unit, and press
.
•
“Z2” on the display of the main unit lights up.
2. Press the input selector of the input source you want to play in the separate
room. On the main unit, after pressing ZONE 2-CONTROL, within 8 seconds
turn the input selector dial to select the input to be played in the separate
room.
3.
To adjust the volume on the pre-main amplifier in the separate room or the
ZONE speaker, adjust with VOL+/– on the remote controller. To do this on the
main unit, press ZONE 2-CONTROL, and then within 8 seconds, adjust the
volume using the MASTER VOLUME dial.
•
If you turn the unit to standby during multi-zone playback, the Z2 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 2 to on while the unit is in standby also switches the
playback mode to playback in a separate room only.
•
When audio is being output from the ZONE SPEAKER, surround back
speakers or height speakers cannot play audio.
•
The audio from externally connected AV components can be output to ZONE 2
only when the audio is analog signal.
•
DSD and Dolby TrueHD audio signals cannot be output to ZONE 2 when
selected with the "NET" or "USB" input selector.
•
If ZONE 2 is on, power consumption during standby will increase.
To set the function to off:
Press
while the remote controller is in the ZONE
control mode. Alternatively, press the ZONE 2-ON/OFF button on the main unit.
