Pioneer VSX-820-S/-K, Руководство по эксплуатации

Страница: 74 / 244

Additional information 11
74
En
Chapter 11:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Take a look at the other
components and electrical appliances being used, because sometimes the problem may lie there.
If the trouble isn’t sorted out even after going through the checks below, ask your nearest Pioneer
authorized independent service company to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity disconnect
the power plug from the outlet and insert again to return to normal operating conditions.
Problem Remedy
The power does not turn
on. • Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the receiver to shut off automatically.
The receiver suddenly
switches off. • After about a minute (you won’t be able to switch the unit on during this
time), switch the receiver back on. If the message persists, call a Pioneer
authorized independent service company.
No sound is output when a
function is selected. • Make sure the component is connected correctly (refer to Connecting
your equipment on page 16).
• Press MUTE on the remote control to turn muting off.
• Press SPEAKERS to select the proper speaker set (see Switching the
speaker system on page 20).
• Press SIGNAL SEL to select the proper input signal (see Choosing the
input signal on page 41).
No image is output when a
function is selected. • Make sure the component is connected correctly (refer to Connecting your
equipment on page 16).
• Select the correct component (use the MULTI CONTROL buttons).
• Check The Input Assign menu on page 46 to make sure you’re assigned
the correct input.
• The video input selected on the TV monitor is incorrect. Refer to the
instruction manual supplied with the TV.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have an
LFE channel.
• Switch the subwoofer setting in
Speaker Setting on page 43 to
YES
or
PLUS
.
• Switch the LFE ATT (LFE Attenuate) on page 39 to
LFEATT 0
or
LFEATT 5
.
VSX-820_SYXCN_En.book 74 ページ ２０１０年４月１２日 月曜日 午後６時５２分