Pioneer VSX-820-S/-K, Руководство по эксплуатации

Страница: 43 / 244

The System Setup menu 06
43
En
English
Français
Deutsch
Nederlands
Italiano
Español
Manual speaker setup
This receiver allows you to make detailed
settings to optimize the surround sound
performance. You only need to make these
settings once (unless you change the
placement of your current speaker system or
add new speakers).
These settings are designed to fine-tune your
system, but if you’re satisfied with the settings
made in
Automatically setting up for surround
sound (MCACC) on page 29, it isn’t necessary
to make all of these settings.
CAUTION
• The test tones used in the System Setup
are output at high volume.
Important
• Depending on the Pre Out setting, there
will be differences in the speaker items that
can be adjusted. The OSD display for these
operating instructions is an example of
when the
Pre Out setting is set to Surr.
Back .
1 Select ‘Manual SP Setup’ then press
ENTER.
2 Select the setting you want to adjust.
If you are doing this for the first time, you may
want to adjust these settings in order:
• Speaker Setting – Specify the size and
number of speakers you’ve connected (see
below).
• Crossover Network – Specify which
frequencies will be sent to the subwoofer
(page 45).
• Channel Level – Adjust the overall
balance of your speaker system (page 45).
•
Speaker Distance
– Specify the distance
of your speakers from the listening
position (page 46).
3 Make the adjustments necessary for
each setting, pressing RETURN to confirm
after each screen.
Speaker Setting
Use this setting to specify your speaker
configuration (size, number of speakers). It is
a good idea to make sure that the settings
made in
Automatically setting up for surround
sound (MCACC) on page 29 are correct.
1 Select ‘Speaker Setting’ from the
Manual SP Setup menu.
2 Choose the set of speakers that you
want to set then select a speaker size.
Use
/
to select the size (and number) of
each of the following speakers:
• Front – Select LARGE if your front
speakers reproduce bass frequencies
effectively, or if you didn’t connect a
subwoofer. Select
SMALL to send the bass
frequencies to the subwoofer.
1
System Setup
1.Auto MCACC
2.Manual SP Setup
3.Input Assign
4.Pre Out Setting
Return
2.Manual SP Setup
Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
Note
1 If you select SMALL for the front speakers, the subwoofer will automatically be fixed to YES . Also, the center, surround,
surround back and front height speakers can’t be set to LARGE if the front speakers are set to SMALL . In this case, all bass
frequencies are sent to the subwoofer.
2.Manual SP Setup
Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
2a.Speaker Setting
Front
Center
Surr
Surr. Back
Subwoofer:
Return
[ SMALL ]
[ SMALL ]
[ NO ]
YES
SMALL
VSX-820_SYXCN_En.book 43 ページ ２０１０年４月１２日 月曜日 午後６時５２分