Pioneer VSX-2016AV Скачать руководство пользователя

Страница: 62 / 79

Controlling the rest of your system

• The remote controls should be 3 cm to 5 cm apart.

Press the corresponding button on the other remote

control that is sending (teaching) the signal to this
receiver’s remote control.

For example, if you want to learn the playback control
signal, press and hold

briefly. The LCD display will

show

if the operation has been learned.

If for some reasons the operation hasn’t been learned the
LCD will display

ERROR

briefly and then display

PRES

KEY

again. If this happens, keep pressing the (teaching)

button as you vary the distance between the two remotes,

until the LCD display shows

Certain buttons represent operations that cannot be

learned from other remote controls.

The buttons

available are shown below (with the exception of the TV
controls, a combination of

SHIFT

and these buttons can

also be learned):

To program additional signals for the current

component repeat steps 4 and 5.

To program signals for another component, exit and
repeat steps 1 through 5.

Press and hold the RECEIVER button for a couple of

seconds to exit and store the operation(s).

Erasing one of the remote control
button settings

This erases one of the buttons you have programmed and
restores the button to the factory default.

While pressing the RECEIVER button, press

SETUP

The remote LCD display shows

SETUP

Use

to select

ERASE

then press

ENTER

The LCD on the remote prompts you for the component
corresponding to the button setting to be erased.

Press the input source button corresponding to the

command to be erased then press

ENTER

The LCD display flashes

PRES KEY

Press and hold the button to be erased for two

seconds.

The LCD display shows

NO CODE

to confirm the

button has been erased.

Repeat step 4 to erase other buttons.

Press and hold the RECEIVER button for a couple of

seconds when you’re done.

Resetting the remote control presets

This will erase all preset remote control preset codes and
programmed buttons.

While pressing the RECEIVER button, press

SETUP

The remote LCD display shows

SETUP

Use

to select

RESET

then press

ENTER

RESET

flashes in the LCD display.

Press and hold

ENTER for about two seconds

The LCD shows

to confirm the remote presets have

been erased.

Confirming preset codes

Use this feature to check which preset code is assigned
to an input source button.

While pressing the RECEIVER button, press

SETUP

The remote LCD display shows

SETUP

Use

to select READ ID then press

ENTER

The LCD on the remote prompts you for the input source
button you want to check.

Note

1 Note that interference from TVs or other devices will sometimes result in the remote control learning the wrong signal.
2 • Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer together or farther apart.

• If the remote LCD shows

FULL

, it means the memory is full. See

Erasing one of the remote control button settings

below to erase a programmed button

you’re not using to free up more memory (note that some signals may take more memory than others).
3 Note that the number key decimal button (

+10

D.ACCESS

) may not be learned with some components.

3 cm to 5 cm

SLEEP

ANAL