- 40 -
En
gl
ish
[Factory Reset]
Touch [OK] to restore the settings to the default settings.
CAUTION
Do not turn off the engine while restoring the settings.
NOTES
•
This setting is available only when you stop your vehicle in a safe
place and apply the handbrake.
•
The source is turned off and the Bluetooth connection is
disconnected before the process starts.
•
Before starting the restore process, disconnect any device that is
connected to the USB port. Otherwise, some settings may not be
restored correctly.
[System Information]
Displaying and updating the firmware version.
CAUTION
•
The USB storage device for updating must contain only the
correct update file.
•
Never turn this product off, disconnect the USB storage device
while the firmware is being updated.
•
You can only update the firmware when the vehicle is stopped
and the handbrake is engaged.
1
Download the firmware update files into your
computer.
2
Connect a blank (formatted) USB storage device to
your computer then locate the correct update file and
copy it onto the USB storage device.
3
Connect the USB storage device to this product
(page 24).
4
Display the [System Settings] screen (page 39).
5
Touch [System Information].
6
Touch [Update].
New firmware version information is displayed.
7
Touch [Update].
Follow the on-screen instructions to finish updating the
firmware.
NOTES
•
This product will reset automatically after the firmware
update is completed if the update is successful.
•
If an error message appears on the screen, touch the display
and perform the above steps again.
[Licence]
Displaying the open source licence.
Menu Item
Description