Pioneer PDP-504CMX, Руководство по обслуживанию

Страница: 144 / 191

PDP-504CMX/1
144
1 2 3 4
1 2 3 4
C
D
F
A
B
E
X CONNECTOR A, B Assy, 43 SCAN A, B Assy
5
Remove the four screws.
6
Disconnect the two pin connectors.
7
Remove the six spacers.
8
Remove the 43 SCAN A and B Assy.
3
Front chassis VR (43M)
43 X DRIVE Assy
43 Y DRIVE Assy
43 Y DRIVE Assy
43 X DRIVE Assy
Front chassis VL (43M)
X CONNECTOR B Assy
43 SCAN B Assy
43 SCAN A Assy
X CONNECTOR A Assy
6
6
4
4
4 4
6
7 7 7 7 7 7
6
6 6
7
9
8 8
9
8
8
4
5 5 5 5
×
3
7
×
4
6
LED OPT Assy
1
2
3
4
5
3
2
1
Flat clamp
Enclosure
sheet 1
Flat clamp
2
Remove the jumper wire by removing the flat clamp.
3
Remove the one screw.
4
Remove the front chassis VL (43M) by removing the five
screws.
1
Remove the one nylon rivet.
43 SCAN A and B Assy
4
Remove the one screw.
1
Remove the enclosure sheet 1.
3
Remove the one nyron rivet.
2
Remove the jumper wire by removing the flat clamp.
5
Remove the LED OPT Assy.
6
Remove the front chassis VR (43M) by removing the five
screws.
7
Remove the seven screws.
8
Remove the two spacers.
9
Remove the X CONNECTOR A and B Assy.
X CONNECTOR A and B Assy
Note:
Enclosure sheet 1 is attached to comply with the safety
standards. Make sure that it will not be shifted or peeled off.
If it is peeled off, securely reattach it in its original place.
Note:
Be sure to remove this screw. If you don't, the connector on
the LED OPT Assy may be damaged.
Note when reassembling the front chassis VR (43M)
Remove or loosen the screws that secure the panel holder in
order not to damage the front protect panel Assy.
Note when reassembling the front chassis VL (43M)
Remove or loosen the screws that secure the panel holder in
order not to damage the front protect panel Assy.