PDP-434CMX
113
5
6
7
8
5
6
7
8
C
D
F
A
B
E
2
Remove the one screw.
1
Remove the one nylon rivet.
3
Remove the LED OPT Assy.
4
Remove the enclosure sheet 1.
2
Remove the jumper wire by removing the flat clamp.
5
Remove the jumper wire by removing the flat clamp.
6
Remove the front chassis VR (43M) by removing the five
screws.
7
Remove the six screws.
8
Remove the X CONNECTOR A and B Assy.
X CONNECTOR A Assy, B Assy, 43 SCAN A Assy and B Assy
3
Remove the one screw.
4
Remove the front chassis VL (43M) by removing the five
screws.
1
Remove the one nylon rivet.
5
Remove the four screws.
6
Disconnect the two pin connectors.
7
Remove the two spacers.
8
Remove the four spacers.
9
Remove the 43 SCAN A and B Assy.
3
Front chassis VR (43M)
43 X DRIVE Assy
43 Y DRIVE Assy
43 Y DRIVE Assy
43 X DRIVE Assy
LED OPT Assy
Front chassis VL (43M)
X CONNECTOR B Assy
43 SCAN B Assy
43 SCAN A Assy
X CONNECTOR A Assy
6
6
4
4
4
3
5
6
7
7
8
8
8
8
5
4
2
6
6
5
6
7
8
7
1
4
1
3
2
9
9
8
4
×
2
×
4
×
2
×
2
6
Flat clamp
Enclosure sheet 1
Flat clamp
Bottom view
X CONNECTOR A and B Assy
43 SCAN A and B Assy
Note:
Be sure to remove this screw. If you don't, the connector
on the LED OPT Assy may be damaged.
Note:
Enclosure sheet 1 is attached to comply with the safety
standards. Make sure that it will not be shifted or peeled off.
If it is peeled off, securely reattach it in its original place.
Note when reassembling the front chassis VR (43M)
Remove or loosen the screws that secure the panel holder in
order not to damage the front protect panel Assy.
Note when reassembling the front chassis VL (43M)
Remove or loosen the screws that secure the panel holder in
order not to damage the front protect panel Assy.