PDP-434CMX
111
5
6
7
8
5
6
7
8
C
D
F
A
B
E
7.1.8 DISASSEMBLY
2
Remove the six screws.
1
Remove the grip by removing the four screws.
3
Remove the sixteen screws.
4
Remove the rear case (43M).
Rear Case (43M), Front Case 434 (CMX)
×
3
1
5
Remove the three screws.
6
Remove the one rivet.
7
Remove the lead cover (4G).
8
Disconnect the flexible cable.
9
Remove the front case 434 (CMX).
Note :
When reattaching the rear case (43M), first attach
the screws for the holes indicated with
∗
1 to place
the rear case (43M) in the correct position.
5
Front case 434 (CMX)
6
7
Turn it not to press the rivet.
(Because when the rivet presses, fit in once again.)
Rivet
Lead cover (4G)
Lead cover (4G)
4
8
KEY CONTROL
Assy
50-inch
43-inch
50-inch
43-inch
Grip attachment position
Grip attachment position
Inner
side
Inner
side
Inner
side
Inner
side
Note:
If only the front case must be removed,
without removing the rear case, perform the steps
5
to
9
.
9
Rear case (43M)
4
Grip
Grip
∗
1
∗
1
2
2
2
1
1
2
1
1
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
First pull the lower part of the
front case 434 (CMX) out
toward you then lift the case up.
2
2
Note:
• When reattaching the grip, be sure to securely
tighten the screws.
• An installation direction of the grip of PDP-
434CMX/ PDP-43MXE1 and PDP-43MXE1-S
(43-inch) is different from PDP-504CMX/ PDP-
50MXE1 and PDP-50MXE1-S (50-inch).
(Refer to the right figure.)