Pioneer PDP-42MXE10, Техническое руководство

Страница: 75 / 188

75
Wall Mount Unit: PDK-WM01
6
Hanging the hook of the PDP side metal fitting on the
wall side metal fitting
1
Hang the hook on the ceiling surface part of the
PDP side metal fitting on the wall side metal
fitting.
2
Raise the lock bar to attach the plasma display.
Make sure that the lock bar is fully lowered.
Hook of the PDP side
metal fitting
Lift the lock bar to its
unlocked position.
Hang the hook.
1
2
Always have at least 2 people do this task.
Always make sure that the hook has been
hung.
Caution
7
Fine adjustment of the left-right tilt of the plasma
display.
If the plasma display is slightly tilted to the left or right
after it is installed on the wall, you can adjust this tilt
by attaching the adjustment metal fitting (at lone
location on the right and on the left).
Insert the tilt adjustment metal fitting in the notch on
the top surface of the PDP side metal fitting that is
tilted downward and attach it by rotating the screw.
1
Rotate the screw until the gap between the wall
side metal fitting and the tilt adjustment metal
fitting disappears. When the gap between the
wall side metal fitting and the tilt adjustment
metal fitting has disappeared, the screw becomes
difficult to rotate and begins to lift up the plasma
display.
2
Rotate the screw to adjust the tilt.
Gap
Screw head
Tilt adjustment
metal fitting
Tilt adjustment
metal fitting
5
Installing the wall side metal fitting on the wall.
Fix it firmly in place symmetrically to the left and right
(4 or more locations).
The screws and bolts used for this step vary according
to the strength and the materials of the wall, so prepare
these separately.
Note
Perform this installation work after confirming the
strength of the wall, columns, etc.
Notes
If speakers are attached, do not hold the
speakers to perform this attachment.
Be careful that the wiring etc. is not caught in the
metal fitting or the plasma display. Be extremely
careful if there is a speaker attached, because if
there is, wiring etc. is easily caught between the
wall and the speaker.
Note
The range that the tilt can be adjusted by the screw
is about 5 mm (3/16 inch) of the external dimension
of the plasma display and the screw rotates about 3
times. Be careful not to rotate the screw too much.
If the screw is turned too much, the metal fitting
may be damaged.