3
En
English
Checking the Enclosed Parts
Check to make sure that you have all the enclosed parts
before assembly and installation.
Table top stand x 1
Support columns x 2
Installation screws
1
(M8 x 20 mm [13/16 inch]: silver) x 2
[used to anchor the support columns and the table top stand]
Installation screws
2
(M8 x 30 mm [1-3/16 inch]:
black) x 2
Installation screws
3
(M8 x 40 mm [1-9/16 inch]:
black) x 2
Hexagonal wrench x 1
(Diagonal size: 5 mm [3/16 inch])
Operating instructions
(this document) x 1
Assembling the Stand
Note
Always assemble it on a flat table etc.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Assembly Procedure
1
Attaching the support columns to the stand.
Insert the head of the screw in the support column into
the hole for the support column in the stand and then
slide it downward.
Front side
Support column
attachment hole
2
Attach the support column to the stand
with the attachment screws
1
on the left
and right of the stand.
Use the enclosed hexagonal wrench to vertically tighten
it in the top hole from the rear.
3
Fully tighten two screws on left and right
of stand which have been loosely screwed
into stand.
Use the provided hexagonal wrench to fully tighten the
attachment screws which have been loosely screwed in
on the left and right sides of the stand.
Tighten the two screws
which have already
been screwed into the
stand.
4
Reconfirm that the attached screw is
firmly tightened.
Attachment screw
1
Operating instructions
Mode d’emploi
Table top stand
Support de couverture de table
PDK-1011
