Pioneer PDA-4001, Техническое руководство

Страница: 22 / 136

22
<Ver. 2.1>
Special installations (Wall hanging)
3.4.2 Wall hanging
This display may be wall-mounted. Since this form of mounting affects ventilation patterns inside, observe the following
requirements:
1
When mounting plate metal, avoid blocking any ventilation holes. Use plate metal of the size indicated in the
following drawing.
2
Provide space for adequate ventilation between the wall and the display.
3
Use plate metal having sufficient strength (with a safety factor of approximately four), and attach at four points (4-
point mounting) as shown below. Since wall installations involve certain hazards, always follow double-safety
procedures.
4
The following table lists proper operating temperatures. Use the display within the listed range of outside air
temperature.
5
Keep deformation of the display to 1 mm, including twisting and bending.
Clearance A to the wall
100 mm or more
50 mm or more
Less than 100 mm
0 to less than 50 mm
Operating temperatures
0 to 40 °C
0 to 40 °C (Animation)
0 to 35 °C (Still)
0 to 30 °C
Remarks
When this display is used with its back surface close to the
wall, interior temperatures will rise. The inner sensor is
activated at approximately 30 °C. Luminance decreases by 30%
and fan speed increases.
Do not block this area at either the top or bottom.
40mm
Do not block this area at either the left or right.
40mm
A
75mm 75mm
Wall
694 mm (center indicated)
75mm 75mm