12
En
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings
*3 Not available when [OFF] is selected in [SUB.W].
You can also access to these menus when the unit is turned off.
SUB.W CTRL
*2*3
Cut-off frequency:
[50HZ],
[63HZ], [80HZ], [100HZ],
[125HZ], [160HZ], [200HZ]
Output level:
[–24] to [+6]
Slope level:
[–12], [–24]
Only frequencies lower than those in the
selected range are output from the
subwoofer.
BASS BOOST
[0] to [+6]
Select the bass boost level.
HPF SETTING
Cut-off frequency:
[OFF],
[50HZ], [63HZ], [80HZ],
[100HZ], [125HZ], [160HZ],
[200HZ]
Slope level:
[–12], [–24]
Only frequencies higher than the high-pass
filter (HPF) cutoff are output from the
speakers.
SLA
[+4] to [–4]
Adjust the volume level for each source
except FM.
Each of the below combinations are set to
the same setting automatically.
•
USB, iPod, ANDROID, and APP (iPhone)
SYSTEM settings
Menu Item
Description
CLOCK SET
Set the clock (page 5).
Menu Item
Description
*1 Depending on your car, this function may not work properly. In this case, contact your
dealer or an authorized PIONEER Service Station.
*2 Please use a commercially available wiring harness for each car model when [PRESET]
mode is engaged, and use a commercially available adapter when in [PIONEER].
12H/24H
[12H], [24H]
Select the time notation.
AUTO PI
[ON], [OFF]
Search for a different station with the same
programming, even if using a preset
station.
AUX
[ON], [OFF]
Set to [ON] when using an auxiliary device
connected to the unit.
ANDROID WIRED
[MEMORY], [APP CONTROL]
Select the appropriate connection method
for an Android device.
P.APP AUTO ON
[ON], [OFF]
Select [ON] to automatically launch Pioneer
ARC APP when an Android device is
connected to the unit via AOA. (Not available
when [MEMORY] is selected in [ANDROID
WIRED].)
S.REMOTE
*1*2
[OFF], [PIONEER], [PRESET]
Select [PIONEER] or [PRESET] according to
your wired remote control.
USB AUTO
[ON], [OFF]
Select [ON] to automatically switch to
[USB] source when a USB device/iPod is
connected to the unit.
Select [OFF] when a USB device/iPod is
being connected to the unit just for
charging.
Menu Item
Description
