This function is available only for
MVH-P8300BT
.
Bluetooth telephone data can be deleted. To protect
personal information, we recommend deleting this
data before transferring the unit to other persons. The
following settings will be deleted.
!
phone book entries on the Bluetooth telephone
!
preset numbers on the Bluetooth telephone
!
registration assignment of the Bluetooth tele-
phone
!
call history of the Bluetooth telephone
!
information of the connected Bluetooth telephone
!
PIN code
1
Press
M.C.
to display the setting mode.
2
Use
M.C.
to select
Yes
.
Turn to change the mode. Press to select.
Cleared
is displayed and the settings are deleted.
To cancel, select
No
.
!
While this function is in use, do not turn off
the engine.
BT Ver. Info.
(Bluetooth version display)
This function is available only for
MVH-P8300BT
.
1
Press
M.C.
to display the Bluetooth (microproces-
sor) version of this unit.
Software Update
(updating the software)
This function is available only for
MVH-P8300BT
.
This function is used to update this unit with the lat-
est software. For information on the software and up-
dating, refer to our website.
1
Press
M.C.
to display the setting mode.
2
Use
M.C.
to select
Yes
to show a confirmation dis-
play.
Turn to change the mode. Press to select.
To cancel, select
No
.
Follow the on-screen instructions to finish updat-
ing the software.
Ever Scroll
(scroll mode setting)
When ever scroll is set to
On
, recorded text informa-
tion scrolls continuously in the display. Set to off if
you prefer the information to scroll just once.
1
Press
M.C.
to turn the ever scroll on or off.
Auto EQ (auto-equalizing)
The auto-equalizer automatically measures
the car
’
s interior acoustic characteristics, and
then creates an auto-equalizer curve based on
that information.
!
To perform this function, dedicated micro-
phone (e.g. CD-MC20) is required.
WARNING
As a loud tone (noise) may be emitted from the
speakers when measuring the car's interior
acoustic characteristics, never perform auto EQ
while driving.
CAUTION
!
Thoroughly check the conditions before per-
forming auto EQ as the speakers may be da-
maged if these functions are performed when:
—
The speakers are incorrectly connected.
(For example, when a rear speaker is con-
nected as a subwoofer output.)
—
A speaker is connected to a power amp de-
livering output higher than the speaker
’
s
maximum input power capability.
!
If the microphone is placed in an unsuitable
position the measurement tone may become
loud and measurement may take a long time,
resulting in battery drainage. Be sure to place
the microphone in the specified location.
Before operating the auto EQ function
!
Carry out auto EQ in as quiet a place as
possible, with the car engine and air condi-
tioning switched off. Also cut power to car
phones or portable telephones in the car, or
remove them from the car before carrying
out auto EQ. Sounds other than the mea-
surement tone (surrounding sounds, en-
gine sound, telephones ringing etc.) may
prevent correct measurement of the car in-
terior acoustic characteristics.
!
Be sure to carry out auto EQ using the op-
tional microphone. Using another micro-
phone may prevent measurement, or result
in incorrect measurement of the car inter-
ior acoustic characteristics.
!
In order to perform auto EQ, the front
speaker must be connected.
!
When this unit is connected to a power
amp with input level control, auto EQ may
not be possible if the power amp
’
s input
level is set below the standard level.
En
36
Section
03
Operating this unit
Содержание MVH-P7300
Страница 187: ...Es 187 Español ...
