Pioneer KURO PDP-LX508D, Руководство по обслуживанию

Страница: 117 / 175

PDP-LX5080D
117
5 6 7 8
5 6
7
8
C
D
F
A
B
E
8. EACH SETTING AND ADJUSTMENT
8.1 ADJUSTMENT REQUIRED WHEN THE UNIT IS REPAIRED OR REPLACED
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.
Y DRI V E Assy N o adjustment required
Other assemblies N o adjustment required
PO W ER SUPPLY Unit
DIGITAL Assy
X DRI V E Assy N o adjustment required
Refer to “ 8 .3 HO W TO CLEAR HISTORY DATA” .
MAI N Assy ( * ) N o adjustment required
Service Panel Assy Refer to “ 8 .3 HO W TO CLEAR HISTORY DATA” and
“ 8 .4 ADJUSTME N TS W HE N THE SER V ICE PA N EL
ASSY IS REPLACED”.
W riting of backup data is required.
Refer to the “ 8 .2 BACKUP OF THE EEPROM
(DIGITAL ASSY)”.
PA N EL SE N SOR Assy W riting of backup data is required.
Refer to the “ 8 .2 BACKUP OF THE EEPROM
(DIGITAL ASSY)”.
When any of the following assemblies is replaced
( * ) : W hen replacing the MAI N Assy, be sure to perform the FI N AL SETUP.