English
11
En
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other
components and electrical appliances being used If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.
SPECIFICATIONS
Cabinet ............ Floor type with PASSIVE RADIATOR system
(Magnetically shielded)
Cabinet material and surface finish............................... MDF
(Medium Density Fiber Board) with realwood finish
Woofer ............................................................30 cm cone type
PASSIVE RADIATOR......................................30 cm cone type
Frequency response ................. 25 – 4,000Hz(set to BYPASS)
Power Amplifier Continuous Power Output (RMS)
..................................................................250 W/4
Ω
(100 Hz)
Input (sensitivity at 100 Hz/impedance)
SPEAKER LEVEL ...................................1.6 V + 1.6 V/15 k
Ω
(both channels in-phase)
LINE LEVEL (RCA jack) .................................... 160 mV/50 k
Ω
Output (Level at 100 Hz/impedance)
LINE LEVEL (RCA jack) ...................................... 160 mV/1 k
Ω
CROSSOVER Frequency
......................................... 50 – 150 Hz (continuously variable)
Outline Dimension............430 (W) x 480 (H) x 430 (D) mm
Weight (without package) .............................................34.5 kg
Power Requirements............................................ 120 V, 60 Hz
Power Consumption .............................................. 56 W, 90VA
Accessories .............................................................Spikes x 4
Bases x 4
RCA plug cord x 1
Power cable x 1
Ground cord x 1
Warranty card x 1
Operating instructions x 1
NOTE:
Specifications and design subject to possible
modification without notice, due to improvements.
Published by Pioneer Corporation.
Copyright © 2005 Pioneer Corporation.
All rights reserved.
is a trademark placed on a product with
Pioneer’s Phase Control Technology.
The Technology enables high-grade 5.1ch
with no delay in the bass area.
SYMPTOM
CAUSE
REMEDY
1
1
1
1
No power is being supplied
(Indicator does not light up when
power switch is turned on.)
• Power supply plug is not
correctly inserted.
• Insert plug securely.
2
2
2
2
No sound
(Indicator is lit.)
• Connection of speaker or
accessory RCA plug cord is
wrong or disconnected.
•
VOLUME
knob is set to
MIN
.
• Check again and connect correctly.
• Turn clockwise slowly.
3
3
3
3
Sound is weak.
(
VOLUME
knob is turned up.)
• Polarity of the speaker cords
(from the amplifier or receiver to
this unit) is reversed.
• Confirm the polarity of the wires and
connect them correctly.
4
4
4
4
Sound is distorted.
• Level is too high.
• Input level is too high.
• Turn the
VOLUME
knob counter-
clockwise to lower the level.
• Turn the amplifier’s output level
(volume, bass control, bass boost)
counter-clockwise to lower the level.
5
5
5
5
Howling noise occurs.
• Power supply to amplifier or
speaker switch is turned off.
• Subwoofer level is set too high.
• Connect power supply to amplifier and
turn speaker switch on.
• Place the subwoofer a good distance
from speakers. Turn the
VOLUME
knob
counter-clockwise to lower the volume.
6
6
6
6
Much noise when listening to
AM or FM broadcasts.
• The AM loop antenna or the FM
indoor antenna is close to this
unit.
• Increase the distance between the AM
or FM antenna (for indoor use) and this
unit.
S-W1EX_En_SRD6034A.book Page 11 Tuesday, October 11, 2005 6:51 PM
