Pioneer DVR-545HX-S, Руководство по эксплуатации

Страница: 35 / 156

Additional information 07
35
En
Tuner
Error Messages
No sound from surround or
center speakers. • Refer to
Channel level setting
on page 28 to check the speaker levels.
• Check that you haven’t selected the AUTO , STEREO , or VIRTUAL mode (see
Listening in
surround sound on page 23).
• Connect the speakers properly (refer to Connecting up on page 8).
• If you’re playing from the DVD recorder, check that the Dolby Digital Out setting is set to
Dolby Digital .
• If the source is 96 kHz, this will be played in stereo. If you want to play it in surround
sound, set the DVD recorder’s 96 kHz PCM Out setting to
96 kHz 48 kHz .
• With television broadcasts, this unit will only output to two channels. To hear a broadcast
in multichannel sound, select
DOLBY PL
(Dolby Pro Logic),
MOVIE
(Dolby Pro Logic II
Movie) or MUSIC (Dolby Pro Logic II Music) in surround mode (on page 23) or an
Advanced surround mode (on page 24).
Can’t operate using the remote
control. • Replace the batteries ( Putting the batteries in the remote control on page 15).
• Operate within 7 m, 30° of the remote sensor ( Using the remote control on page 14).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• For operating the DVD recorder, make sure that the control cable and coaxial cable are
connected. (page 8)
• If the receiver subwoofer is connected to a Pioneer plasma display with an SR+ cable,
check that the plasma display is switched on. Point the remote control at the plasma
display in order to operate the receiver subwoofer.
• Check that nothing is mistakenly plugged into the
CONTROL IN jack.
Problem Remedy
Problem Remedy
Considerable noise in radio
broadcasts. • Connect the AM antenna (refer to Connecting up on page 8) and adjust the direction and
position for best reception. You may also connect an additional internal or external AM
antenna (refer to
Connecting external antennas
on page 30).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You
may also connect an outdoor FM antenna (see
Connecting external antennas on page 30).
• Turn off other equipment that may be causing the noise or move it further away.
Auto tuning does not pick up
some stations. • The radio signal is weak. Auto tuning will only detect radio stations with a good signal.
For more sensitive tuning, connect an outdoor antenna.
Message Description
2CH ONLY • An operation is prohibited because it is only applicable to 2 channel sources, while the
current source is a multichannel source.
96K
• An operation is prohibited because the source is 96 kHz digital.
EXIT • Appears when a menu is automatically exited after a set period of inactivity.
NOISY • Background noise is too high to complete MCACC setup successfully.
ERR MIC • An error occurred during MCACC setup because the microphone is not connected or is
not connected properly.
ERR SP • An error occurred during MCACC setup because the speakers are not connected or are
not connected properly.
EEP ERROR • Contact your Pioneer authorized service center or your dealer for servicing.
NO SPTYP • Try switching the unit off then on again. If the error still appears, please contact a
Pioneer authorized service center or your dealer.