Pioneer DVR-545HX-S, Руководство по эксплуатации

Страница: 149 / 156

Additional information 17
149
En
• This channel’s TV system is different from the
recorder’s setting. The TV system (PAL, NTSC, etc.) of the current channel is
different from the TV system settings of this recorder.
• Recording failed due to a TV system mismatch. Press
DISPLAY to clear message. The timer recording failed because the TV system of the
channel set for recording was different from the setting of
the recorder.
• Playback has stopped because the TV system is
different than the recording. During recording or timer recording standby, the TV System
(PAL, NTSC, etc.) of the playback video changed, causing
playback to stop automatically.
• You are not allowed to watch this Conditional Access
Program.
A CA module or smart card (obtained from your service
provider) is required to watch the selected program. Insert
the supplied module or card into the Common Interface card
slot on the rear of the recorder (page 47).
• There is no DV input or the input signal is unrecordable. No signal was detected at the DV IN jack. This may appear if
a blank section of DV tape is playing in the connected
camcorder.
• No DV camcorder connected. The camcorder is not connected properly, or the camcorder
is switched off.
• You cannot connect more than one DV camcorder at
a time. This recorder’s DV jack supports connection to just one
camcorder.
• Cannot operate the DV camcorder. This recorder cannot operate the DV camcorder. Try switching
off the camcorder then turn it back on again.
• Could not operate the DV camcorder. This recorder was not able to operate the DV camcorder.
• The DV camcorder is not set for playback. Please
select playback mode on the DV camcorder. The camcorder is in camera mode. Switch it to playback
mode.
• Searching for a printer. Please wait a moment. To
cancel, press ENTER. This message is displayed when the recorder is scanning for
a connected printer, or when the printer is not yet ready for
printing. If there is no printer connected, please connect one.
If the message does not disappear, try disconnecting then
reconnecting the USB cable.
(Note that this recorder may not work correctly with all printers.)
• The printer is not ready or is not
connected. Please check the printer. This message is displayed when communication could not
be established with the printer. See the Troubleshooting
section if you do not know the cause.
• Printing has been canceled because ... This message is displayed when there is a printer error
during printing. After checking the printer for the cause of
the error, either reconnect the printer and start the printing
job again, or select "Yes" to resume printing (select "No" to
cancel the print job). See also the operating instructions that
came with your printer for possible causes of print errors.
Message Explanation/Action