Setting up your front speakers
Make sure you have all the accessories.
Speaker
Stem
Ruler
Base
Speaker cord
Captive washer
screws
Use a ruler to measure the
height of your TV, then make
a note of the two screwholes
you will need to use (see
below) based on this height
(the screws will be fixed later).
95–105cm
TV height:
105 –115cm
115 –125cm
Thread the cord extending from the
bottom of the stem of the speaker stand
through the base as shown.
From this step onwards, assemble
with the speaker, stem and base resting
horiziontally on a work surface.
Attach the supplied cord
to the cord you threaded
through the base in the
previous step.
Use the supplied flathead
screws to fix the stem to the
base of the speaker stand.
Attach the speaker cord extending from the top
of the stem to the speaker as shown below. Make
sure the color-coded sleeves of the speaker wires
match the speaker terminals.
Color-
coded
sleeves
Black
Red
Secure the wire by wedging it
into the groove on the back of
the speaker as shown below.
Adjust the height of the speaker
stand according to that of your TV.
Tighten the screws to securely fix
the speaker in place.
Twist and pull
off the protective
shields on each
wire.
Use the captive washer
screws to fix the speaker to
the stem of the speaker
stand (using the holes you
selected in the first step).
Flathead screws
Run the speaker wire
through the guide on
the rear of the base
then push on the cap.
Cap
<ARE7322-A>
Published by Pioneer Corporation.
Copyright © 2002 Pioneer Corporation.
All rights reserved.
Printed in Thailand
