6
En
WARNING
•
Keep hands and fingers clear of this product when opening, closing, or adjusting the LCD panel. Be
especially cautious of children’s hands and fingers.
•
Do not use with the LCD panel left open. It may result in injury in the event of an accident.
CAUTION
•
Do not open or close the LCD panel forcefully. It may cause a malfunction.
•
Do not operate this product until the LCD panel has completely opened or closed. If this product is
operated while the LCD panel is opening or closing, the LCD panel may stop at that angle for safety.
•
Do not place glass or can on the open LCD panel.
1
Press .
2
Touch
or
to adjust the angle of the LCD panel.
3
Touch .
Returns to the previous screen.
CAUTION
•
Pressing the RESET button resets settings and recorded contents to the factory settings.
– Do not perform this operation when a device is connected to this product.
– Some of the settings and recorded contents will not be reset.
•
The microprocessor must be reset under the following conditions:
– Prior to using this product for the first time after installation.
– If this product fails to operate properly.
– If there appears to be problems with the operation of the system.
– If your vehicle position is shown on the map with a significant positioning error.
1
Turn the ignition switch OFF.
2
Press RESET with a pen tip or other pointed tools.
Basic operation
Notes on using the LCD panel
Adjusting the LCD panel angle
Resetting the microprocessor
Z910DAB
Z910DAB
Settings and recorded contents are reset to the factory settings.
Remove the insulation sheet before use.
WARNING
•
Do not ingest the battery, Chemical Burn Hazard.
(The remote control supplied with) This product contains a coin/button cell battery. If the coin/
button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to
death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and keep it away from
children.
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
•
Batteries (battery pack or batteries installed) must not be exposed to excessive heat such as sunshine,
fire or the like.
CAUTION
•
Remove the battery if the remote control is not used for a month or longer.
•
There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or
equivalent type.
•
Do not handle the battery with metallic tools.
•
Do not store the battery with metallic objects.
•
If the battery leaks, wipe the remote control completely clean and install a new battery.
•
When disposing of used batteries, please comply with governmental regulations or environmental
public institutions’ rules that apply in your country/area.
Point the remote control in the direction of the front panel to operate.
Preparing the remote control
Using the remote control
How to replace the battery
Insert the CR2025 (3 V) battery with the plus (+) and
minus (-) poles orientated properly.
