En
gl
ish
- 132 -
TEMP
→
The temperature of this product is
outside the normal operating range.
– Wait until this product returns to a
temperature within the normal
operating limits.
Product overheat, For protection the
System will shut down automatically in 1
minute. Re-cycle the ignition to restart
the product If this message keeps
showing, please contact your dealer or
local service centre
→
The temperature is too high for this
product to operate.
– Follow the instructions displayed on
the screen. If this does not solve the
problem, contact your dealer or an
authorised Pioneer Station for
assistance.
Positioning is not possible due to
hardware error. Please consult your
dealer or local authorised service centre.
→
The location display is not possible due
to hardware failure.
– Contact your dealer or an authorised
Pioneer Station for assistance.
No GPS antenna. Check connection.
→
GPS reception is lost.
– Check the aerial connection. If the
message fails to disappear even after
the engine is switched off/on, contact
your dealer or an authorised Pioneer
Station for assistance.
GPS antenna problem detected. Contact
dealer or service center.
→
GPS aerial lead is short-circuited.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Calibration will start, but may be
inaccurate without speed pulse.
→
The speed pulse sensor is not
connected correctly.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Sensor error. Please contact your dealer
or Pioneer Service Center.
→
An error has occurred with the sensor.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Detected unusual speed pulses.
→
The speed pulse cannot be detected
correctly.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Detected changes in the installation
angle or position. The in-dash receiver is
updating the sensor learning data.
→
Changes in the installation angle or
position are detected.
– Wait until the sensor learning finishes.
Speed pulse wire is not connected. The
system will operate in simple hybrid
mode.
→
Speed pulse wire is not connected.
– The speed pulse cannot be detected if
the speed pulse wire is not connected
correctly.
Check Antenna
→
The aerial connection is incorrect or an
unusual voltage has been detected.
– Turn the ignition switch OFF and
connect the aerial correctly. After
connecting, turn back ON again.
Error-02-9X/-DX
→
Communication failed.
– Turn the ignition switch OFF and back
ON.
– Disconnect the USB storage device.
DAB tuner
USB storage device