Pioneer AVIC-X920BT, Руководство по установке

Страница: 22 / 56

!
The cords must not cover up the area
shown in the figure below. This is neces-
sary to allow the amps and navigation me-
chanism to dissipate heat.
Do not cover this area.
!
The semiconductor laser will be damaged
if it overheats, so don
’
t install the naviga-
tion unit anywhere hot
—
for instance, near
a heater outlet.
Parts supplied
The navigation unit Binding screw
(5 mm × 8 mm)
(8 pcs.)
Flush surface screw
(5 mm × 8 mm)
(8 pcs.)
Installation using the screw holes
on the side of the navigation unit
%
Fastening the navigation unit to the
factory radio-mounting bracket.
Position the navigation unit so that the brack-
ets screw holes and its screw holes are
aligned (are fitted), and tighten the screws at 3
or 4 locations on each side.
Use either the binding screws (5 mm × 8 mm)
or flush surface screws (5 mm × 8 mm), de-
pending on the shape of the bracket
’
s screw
holes.
If the pawl gets in the
way, bend it down
Dashboard or console
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this navigation
system.
Factory radio mounting bracket
En
22
Section
04
Installation