Black plate (67,1)
Connecting the system
FUSE
Secure the RGB cable with
the 11 mm (.4 in) screw
The navigation unit
Where applicable, secure the cable to
the AV receiver using an 11 mm (.4 in)
screw (supplied).
Insert one end of the RGB cable into the “DATA BUS”
slot on the side of this product and secure it with an
11 mm (.4 in) screw (supplied). Connect the other
end of the cable to RGB IN input on the back of your
Pioneer AV receiver.
TMC aerial (supplied)
Attach the GPS aerial to
the “GPS ANTENNA” jack
on the side of this product.
GPS aerial (supplied)
TMC aerial IF
AV receiver
RGB cable (supplied)
Yellow (B+)
To the terminal that the power is always supplied
regardless of the ignition switch position.
Black (GND)
To vehicle (metal) body.
Power cord (supplied)
Fuse (3 A, 250 V)
Affix the double-sided tape (supplied)
on the surface as level as possible
where the GPS aerial faces the
window. Place the GPS aerial on the
double-sided tape.
2.65 m
3 m
2 m
<127075005641>67
Engb
67
Chapter
13
Installation
Installation