Pioneer AVIC-5201NEX, Руководство по установке

Страница: 6 / 32

6
En
<CRD5002-A> UC
Connecting the power cord (2)
Pink (CAR SPEED SIGNAL INPUT)
This product is connected here to detect the distance the vehicle travels. Always connect the vehicle’s speed
detection circuit. Failure to make this connection will increase errors in the vehicle’s location display.
WARNING
IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECTRICAL
SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE´S ANTILOCK BRAKING
SYSTEM, AUTOMATIC TRANSMISSION AND SPEEDOMETER INDICATION.
CAUTION
It is strongly suggested that the speed pulse wire be connected for accuracy of navigation and better
performance.
NOTE
The position of the speed detection circuit and the position of the parking brake switch vary
depending on the vehicle model. For details, consult your authorized Pioneer dealer or an installation
professional.
WARNING
LIGHT GREEN LEAD AT POWER
CONNECTOR IS DESIGNED TO
DETECT PARKED STATUS AND MUST
BE CONNECTED TO THE POWER
SUPPLY SIDE OF THE PARKING
BRAKE SWITCH. IMPROPER
CONNECTION OR USE OF THIS
LEAD MAY VIOLATE APPLICABLE
LAW AND MAY RESULT IN SERIOUS
INJURY OR DAMAGE.
This product
Power supply
Power cord
Power supply side
Ground side
Parking brake switch
Light green (PARKING BRAKE)
Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power
supply side of the parking brake switch.
If this connection is made incorrectly or omitted, certain functions of this product will be
unusable.
Violet/white (REVERSE-GEAR SIGNAL INPUT)
This is connected so that this product can detect
whether the vehicle is moving forwards or
backwards. Connect the violet/white lead to the lead
whose voltage changes when the shift lever is put in
reverse. Unless connected, the sensor may not detect
your vehicle traveling forward/backward properly,
and thus the position of your vehicle detected by the
sensor may be misaligned from the actual position.
NOTE
When you use a rear view camera, please make
sure to connect this lead. Otherwise you cannot
switch to the rear view camera picture.