Pioneer AVH-P3250BT, Руководство по эксплуатации

Страница: 67 / 96

2 Touch TV Signal on the system menu to
select the appropriate TV signal.
Auto
—
PAL
—
NTSC
—
PAL-M
—
SECAM
Selecting the area group
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch TV Country Group on the func-
tion menu.
3 Touch
c
or
d
until the desired area
group appears.
Country1
(CCIR channel)
—
Country2
(IN
channel)
—
Country3 (CHN channel)
—
Country4
(U.K. channel)
—
Country5
(OIRT
channel)
—
Country6
(AUSTRALIA channel)
—
Country7 (SAF channel)
Auto EQ (auto-equalizing)
The auto-equalizer automatically measures
the car
’
s interior acoustic characteristics, and
then creates an auto-equalizer curve based on
that information.
WARNING
As a loud tone (noise) may be emitted from the
speakers when measuring the car's interior
acoustic characteristics, never perform auto TA
or auto EQ while driving.
CAUTION
!
Thoroughly check the conditions before per-
forming auto EQ as the speakers may be da-
maged if these functions are performed when:
—
The speakers are incorrectly connected.
(For example, when a rear speaker is con-
nected as a subwoofer output.)
—
A speaker is connected to a power amp de-
livering output higher than the speaker
’
s
maximum input power capability.
!
If the microphone is placed in an unsuitable
position the measurement tone may become
loud and measurement may take a long time,
resulting in battery drainage. Be sure to place
the microphone in the specified location.
Before operating the auto EQ function
!
Carry out auto EQ in as quiet a place as
possible, with the car engine and air condi-
tioning switched off. Also cut power to car
phones or portable telephones in the car, or
remove them from the car before carrying
out auto EQ. Sounds other than the mea-
surement tone (surrounding sounds, en-
gine sound, telephones ringing etc.) may
prevent correct measurement of the car in-
terior acoustic characteristics.
!
Be sure to carry out auto EQ using the op-
tional microphone. Using another micro-
phone may prevent measurement, or result
in incorrect measurement of the car inter-
ior acoustic characteristics.
!
In order to perform auto EQ, the front
speaker must be connected.
!
When this unit is connected to a power
amp with input level control, auto EQ may
not be possible if the power amp
’
s input
level is set below the standard level.
!
When this unit is connected to a power
amp with an LPF, turn this LPF off before
performing auto EQ. Also set the cut-off fre-
quency for the built-in LPF of an active sub-
woofer to the highest frequency.
!
The distance has been calculated by com-
puter to be the optimum delay to give accu-
rate results for the circumstances, so
please continue to use this value.
—
The reflected sound within the car is
strong and delays occur.
—
The LPF on active subwoofers or exter-
nal amps delay the lower sounds.
!
Auto EQ changes the audio settings as fol-
lows:
—
The fader/balance settings return to the
center position. (Refer to
Using fader/
balance adjustment on page 46.)
—
The equalizer curve switches to Flat .
(Refer to page 46.)
En
67
Section
13
Menu
operations
Menu operations