AVD-W6000
Sensor
POWER
ON/OFF
CN4
Power
OUT
CN9
CN10
CN11
CN6
Monitor
(AVX-P7000CD)
CN2
Hideaway
(AVX-P7000CD)
CN7
CN3
CN8
Hideaway
(TV-W808)
Monitor
(TV-W808)
GND
W808/W818
Power ON/OFF
Monitor
(AVIC-500)
Navigation
(AVIC-500)
Please don`t connect
two items at the same
time.
SP AMP SW
OSD CONT
AMP
LESS
AMP
PAL/NTSC SW
PAL
NTSC
GGW1010
Monitor for
repair products
Pattern generator
Connect the VTR to the VIDEO IN terminal.
Connect to the
CN4 terminal.
(Use GGD1211.)
Set the NTSC.
POWER ON is completed
when the SW is raised
upward pulling up it this side.
Monitor rear case
Remove the rear case
and perform single
power-on operation.
6. ADJUSTMENT
6.1 JIG CONNECTION DIAGRAM
-
Method of singly operating the monitor section using GGW1010
Preparations for jigs
1. GGW1010
2. Equipment having composite image outputs (power generator, VTR, etc.)
3. RCA video cable
4. GGD1211 (20P RGB cable)
Setting of GGW1010
1. Connecting connector number: Connect to CN4.
2. PAL/NTSC SW:
Set the NTSC side.
3. VIDEO IN terminal:
Connect with a pattern generator.
Power-on method
1) Open the rear case of the monitor.
2) Strap the probe land (right side) of the monitor unit with GND.
3) Strap the TEST land (lower left/red silk printing) on the monitor base plate with GND.
4) Connect the monitor with jigs and turn on the power supply of the jigs.
Note) When the power could not be turned on, turn off the power supply of the jigs and perform the aforementioned operation
after about one minute.
Monitor unit
A probe land is installed in the
component side of the monitor unit,
and the land of red silk printing is
strapped with GND.
A probe land is installed in the
component side of the monitor unit,
and this is strapped with GND.
TP3001(RED)
TP3002(WHITE)
IC3601
IC3701
Connection method
48
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
