PIONEER DJ 0020108714, Руководство пользователя

Страница: 6 / 60

En
6
Part names and functions
Rear panel, front panel
PHONES
LINK
CH4 EXTENSION CH3 CH2 CH1
IN
OFF ON
75
MASTER2 REC OUT MASTER1
WORD CLOCK
DIGITAL OUT
INTERNET
DIGITAL IN BOOTH
AES/EBU
2 4 5 4 5 5 4 5 4 6 6 1 7 8
k
9 g h c b d j a f i e
3
1 Kensington security slot
2
POWER button (page 13 )
Turns this unit’s power on and off.
3 EXTENSION terminal (page 11 )
Used when extending PRO DJ LINK. Connect this to the LAN termi-
nal of a computer with rekordbox installed, etc.
4
PHONO terminals (page 11 )
Connect to a phono level (MM cartridge) output device. Do not input
line level signals.
To connect a device to the [
PHONO
] terminals, remove the short-
circuit pin plug inserted in the terminals.
Insert this short-circuit pin plug into the [
PHONO
] terminals when
nothing is connected to them to cut external noise.
5
LINE terminals (page 11 )
Connect to a DJ player or a line level output component.
6
SIGNAL GND terminal (page 11 )
Connects an analog player’s ground wire here. This helps reduce
noise when the analog player is connected.
7
MIC2 terminal (page 11 )
Connects a microphone here.
8
MIC1 terminal (page 11 )
Connects a microphone here.
9 INTERNET terminal
Connect to a router, etc. that is connected to the Internet. Used when
connecting with the KUVO system.
Connect a device to be connected to PRO DJ LINK not to this termi-
nal but to the [
EXTENSION ] terminal.
a
DIGITAL IN terminal (page 11 )
Connect these to the digital coaxial output terminals on DJ players,
etc. The sound may be momentarily interrupted when the output
signal sampling frequency is switched.
b 75
Ω
termination ON/OFF switch
c
WORD CLOCK input terminal
Set the external clock generator to MASTER and implement digital
master output synchronized with another device.
Use a cable with an impedance of 75 Ω for the connection between
the terminals. Performance is not guaranteed when a cable with an
impedance of other than 75 Ω is used.
Change the 75 Ω termination ON/OFF switch setting according to
the connection method.
— ON
—
For connecting with the external clock generator on a one-to-
one basis
—
For terminating with this unit when connecting a combina-
tion of multiple devices
—
OFF
— For terminating with another device when connecting a
combination of multiple devices