Button puts the unit directly into
Dehumidifying
operation at the original factory humidity setting
(60% RH). Pressing the Power Button again will
stop the unit from operating.
2. Continue Button:
Pressing this button while the
unit is operating will put the unit into
Continuous Dehumidifying
mode.
3. Hu Button:
Pressing this button while
the unit is operating will increase the humidity
setting. The range is from 35%RH to 80%RH.
4. Humidity - Button:
Pressing this button while
the unit is operating will decrease the humidity
setting. The range is from 80%RH to 35%RH.
5. Turbo Fan Button:
Pressing this button puts the
fan speed on high.
6. Normal Fan Button:
Pressing this button puts
the fan speed on low.
7. Power Indicator:
At first when connecting to
power, the Power Indicator will flash slowly.
Once unit is operating it will stay on, and turn off
when unit is off.
8. Continue Indicator:
Lights up when unit is in
Continuous Dehumidifying
mode.
9. Full Indicator:
Lights up when Water Tank is
full; the unit then will stop operating.
10. Turbo Indicator:
Lights up when the Turbo
Button is pressed and the fan is on high.
11. Normal Indicator:
Lights up when the Normal
Fan Button is pressed and the fan is on low.
NOTE:
This unit has an automatic shut-off. If the
bucket is full or is not replaced correctly, the unit will
not start and will display a “P2” warning. Please be
sure bucket is not full or inserted correctly.
For Continuous Drainage:
If a drain is located nearby, a 1/2” ID hose (sold
separately) can be connected to the unit for continu-
ous draining.
1. On the rear on the unit, carefully remove the rub-
ber plug from the drain hole (see Figure 2 on
page 3) and slide the drain hose into the drain
hole.
2. Remove the Water Tank then connect the water
hose to the connector located above the water
tank to the left.
3. Be sure the hose has no bends or kinks.
4. Place the other end of the hose into a suitable
drainage facility, and
replace Water Tank
.
NOTE:
The drain is not pressured; it is gravity assist-
ed. Please be sure to note that the end of the hose
in the draining facility MUST be below the connector
in the unit. Any inclination of the drain hose will
cause the drain hose to back up to the unit and
cause a leak!
The Control Panel:
1. Power Button:
Power indicator blinks slowly
when the unit is plugged in. Pressing the Power
Figure 3: Control Panel
1
2
3
4
5
6
7
8
9
10
11
Operation (cont.)
FOR BEST RESULTS:
CLEAN AIR FILTER EVERY
TWO WEEKS.
Residential
Dehumidifier
Page 4
Pinnacle Products International, Inc. Residential Dehumidifier Owners’ Manual
