Pima PIMAGUARD, Инструкция по установке и эксплуатации

Страница: 29 / 62

Sentinel & PimaGuard
Installation Guide 29
Sentinel status events
The Sentinel’s status is represented by 4 bits. The reports are sent as 7F events and indicate the following:
SAR (Stand Alone Repeater) Events:
A
PPENDIX
D S
TRUCTURED
C
OMMUNICATION
F
ORMATS
Legend
All symbols are in ASCII; not case-sensitive.
A= Account (decimal, max. 10 digits)
L= Account (hexadecimal, max. 10 digits)
E= Event (max 4 digits, normal form as is; PAF/NPAF/EPAF in alphabetic order, upper case)
K= Key and Siren Status
T= Event type:
1 - Alarm/Disarming
3 - Reset/Arming
6 - Previous event
Q= Event type:
E - Alarm/Disarming
R - Reset/Arming
P - Previous event
U - Unknown event
Z= Zone (decimal)
P= Partition (decimal)
I= Caller ID number, digits
C= Checksum
HH:MM:SS = Time structure. The structure cannot be broken, nor changed
DD/MM/YY= Short date structure. The structure cannot be broken, nor changed
DD/MM/YYYY= Long date structure. The structure cannot be broken, nor changed
\= Next 2 digits value is in hexadecimal (must use 2 digits)
#= Media number, Repeater Channel/Line/Radio/COMM
*= Decoder ID, is taken from the user definitions of the input format (decimal, 0-default)
[]= Source options; every 2 characters represent a condition and its value, to be placed in the frame. See the next examples.
Code Event
00 Test. The beep does not sound on this error.
No code Invalid Answer: the input repeater answer is unexpected. It indicates errors in the physical channel (antenna, noises, etc.).
7D Call Error (only if “Caller ID” is active). The beep does not sound on this error.
7E Critical Temperature!
FE Reset Temperature
7F General Fault. An unidentified error. Can be any of the errors in this table, such as Sentinel errors, RAM memory error or
Pattern Error. For Example: account #65056 or #8191 for repeaters route. This happens when the output frame to the CMS
cannot support account or event size.
TN (PAF) Repeater failure. The beep does not sound on this error.
Bit Event
0 Sentinel chip overflow
1 Sentinel is not responding
4 Configuration file error
7... 0 =0xFF General fatal error
Hex Code Event
60 Tamper open
61 Zone #1 open
62 Zone #2 open
63 AC fault
64 Low battery
E0 Tamper restore
E1 Zone #1 restore
E2 Zone #2 restore
E3 AC restore
E4 Low battery restore