background image

1. Contents:
• Pocket remote (Transmitter)

• 22 V DC 5 A Safety-Approved 120 V Power Supply

• R/C Analog DC Controller (Receiver)

• DC adapter cable for power supply

1.1 Technical data
Transmitter (Pocket Remote)

Number of channels: 8

Frequency range:  

2.4 GHz

Range approx.:  

30 m

Power supply:  

1x 3 V CR2025

Weight approx.:  

30 g

Receiver (R/C Analog DC Controller)

Number of channels:   8

Speed steps:  

28 (14 steps if supplied with 7-16 V input)

Frequency range:  

2.4 GHz

Range approx.:  

30 m

Power supply:  

16-24 V DC

Max. current:  

4.5 A Max to Track

 

2 A Max for Accessories; 5 A Max Combined

Weight approx.:  

150 g

Power Supply

Input:  

100 – 240 V AC

Output:  

22 V DC 5 A

Weight approx.  

300 g

FOR INDOOR USE ONLY

2. Installation and Connection:

Connect the track power clamps and any DC accessories (switch control 

boxes, lights, etc.) to the correct terminals on the back of the R/C Controller 

(1).  Connect the “pigtail” power cord adapter to the input terminals on the 

back of the R/C Controller.  Note the correct polarity of the wires (2).  Con-

nect the pigtail to the plug on the power supply (3).  Make sure to have an 

operating Pocket Remote set to the same channel as the R/C Controller 

and in-hand to immediately control operation.  Then, after confirming that 

all connections are correct and secure, plug the power supply into a 120V 

grounded AC outlet (4).
3. Channel Selection

To communicate with each other, the R/C Controller (Receiver) and Pocket 

Remote (Transmitter) must both be set to the same channel.  They are 

factory set to channel 0, but any one of the 8 channels, numbered 0-7, may 

be selected.

Up to 8 sets of R/C Controllers and Pocket Remotes can operate in the 

same area without interference by setting each set to a different channel.  

Or, one Pocket Remote can operate up to 8 R/C Controllers by setting 

them all to the same channel.

If using a 35040 Loco Receiver in the same area, keep in mind that this 

operates in the same channel range.  And it may be necessary to use a 

different channel to avoid interference with other nearby radio devices in 

the 2.4GHz radio range. 
R/C Controller (Receiver):

1. Lift up the clear plastic lid on the R/C Controller.

2. Pull off the cover.

3. Now you have access to the DIP rotary switch.

4. The direction of the arrow indicates the channel that has been set.

5. Use a small flat screwdriver to set the channel on the DIP turn switch.
Pocket Remote (Transmitter):

1. Remove the small cover on the back of the Pocket Remote.

2. You now have access to the DIP rotary switch.

3. The arrow direction indicates the set channel.

4.  You can adjust the channel by turning it with a small flat screwdriver. 

35028 R/C Analog Power Set

#35270 Power Clamp

(not included)

black

120 V~ AC

6,4 VA 36 VA

40 VA

 

Отзывы: