Pike RoboSign MK3, Руководство оператора

Страница: 6 / 16

4
Setting up
1
Ensure that no other RoboSign systems are within 1000
metres of your installation.
2
Ensure the supplied antennas are fitted to the two base units
and the remote control. If the Stop-Go boards are attached
to the base units, remove them.
3
At each end of the works zone, place a base unit where it will
be clearly seen by drivers but will not cause an obstruction
to vehicles or pedestrians. The base units should not be
more than 200 metres (656 feet) apart.
Note: Base units weigh more than 25Kg,
do not attempt to move one alone,
always work together with a colleague.
Ensure that the arrow sticker on the top
panel of each base unit points towards
the approaching traffic:
4
On the remote control, press the
ON/
OFF
button to switch it on. The centre
green Status indicator should illuminate,
followed by the two red Status indicators
either side a few seconds later. If this
does not occur, please see page 8.
5
On one of the base units, press the front
panel
RESET
button that is located next to the charging
connector. This will switch the unit on and prompt it to search
for the controller.
When the base unit and remote control make contact, the
red
Base unit A
status indicator on the remote control will go
out.
6
Repeat steps 3 and 5 on the other base unit. When that base
unit and the remote control make contact, the red
Base unit B
status indicator on the remote control will go out.
continued
Installation
Pre-installation checks
It is important to inspect all parts of the system before attempting
to use them for traffic control. Please carry out the following
checks:
• Confirm that both base units and the remote control are all
MK3 (earlier models cannot be mixed):
Remote control: Clearly
marked with RoboSign MK3
Base units: Clearly marked
with RoboSign MK3
• Check that both base units and the controller are properly
charged:
Remote control: The top
centre green indicator
should be on, the lower
centre indicator should be
off (see page 7)
Base units: The volt meter
needle should be in the
green area. If not, the unit
needs to be charged (see
page 8)