1.FILLING THE WATER TANK (B)
Caution: Do not overfill. Max water capacity 450ml. The Water Tank (B) can be filled at
anytime after the pressure and temperature has been release sufficiently.
• Remove the Filler Cap (H) by turning anti-clockwise.
• Fill the Water Tank with soft or distilled water. The Home-tek Water Softener Bottle
is designed and recommended for this purpose. However, any clean jug can be used
to fill the Water Tank
- but please
NOTE
- only softened or distilled water must be used in this product.
After filling replace the Filler Cap by turning it clockwise.
• Your Steam mop has a built in safety feature which ensures that if the unit is left
without water and the tank boils dry then the unit will automatically cut off the
power to the heater. If this occurs then before the product can be used again it has to
be left for approximately 10 minutes to cool down after which the Reset Button (L )
can be pressed and the unit will reset.
• The Steam mop has a safety Filler Cap (H ) which can only be released when there
is no pressure in the boiler. The Filler Cap can only be unscrewed after the unit has
cooled down and there is no pressure in the boiler.
3
.
POWER CABLE
Before using the appliance, completely release the full length of the power cable.
CAUTION:
Do not leave the appliance in one area when hot as this may damage the
floor surface.
4.
RED POWER ON / OFF INDICATOR LIGHT (D) / GREEN WATER TANK
ALERT LIGHT (E)
When the handle shaft is placed securely and the tank filled with water, plug
the appliance into a mains electricity supply, at this point the Red Indicator Light (D )
will illuminate.
When you are ready to start cleaning press the Foot Switch (F) this activates the heater.
At this point the green
indicator light (E ) will illuminate. The Green Water Tank Alert Light (E) will go out if
the Water Tank needs re-filling.
IMPORTANT
: Never use more than 5 pounds force on the foot switch. Excessive force
willdamage the switch.
CAUTION:
Always turn off all the switches when refilling with water and always
unplug the
product after use.
5. REFILLING THE STEAM MOP
Always make sure that your Steam Mop has cooled before attempting to unscrew the
Safety Filler
Cap ( ) to refill your mop. After refilling with distilled or softened water, plug
the appliance into a
mains electricity ssupply socket andthe Red Indicator Light (D) will illuminate
as described above.
Then press the foot operated Foot Switch (F) this activates the heater and the Green
Water Tank
Alert Light (E) will illuminate. When both lights are ON steam will start to come from
the base of
the product and you are now ready to start cleaning the floor.
Note: It may initially take a few minutes before steam is produced after both lights
illuminate.
IMPORTANT:
Never execute more than 5 pounds force on the Pump Switch (F),
excessive force will damage the switch.
CAUTION:
Always turn off all the switches after usage and when refilling with water.
6. CLEANING PAD (I)
The cleaning pad is held in position by special gripping strips which grip the main base
unit (A).
Align these with the grippers on the main base and press into place smoothing the
whole surface to remove any wrinkles.
To remove the pad for cleaning, just peel off. To clean the cloth, just machine wash,
(MAX. TEMP. Setting 60º C) or hand wash in hot soapy water and rinse. Should you
experience stubborn stains on your floor, it is possible to dampen the stain
with detergent before steaming it with your mop, but do ensure that the detergent
is compatible with the surface being cleaned.
NOTE: We only recommend the use of genuine accessories (These can be purchased
from the web site).
3
4
